• Description
  • Technical Specs
  • Installation
  • Downloads

Pipe Wrap FormaShield.jpgEl sistema FormaShieldTM, una solución compuesta de reparación de alta resistencia, refuerza las tuberías que contienen cargas de fleje y axiales. Su resina epoxi cuenta con refuerzo de fibra de vidrio triaxial y se puede aplicar en el lugar, permitiendo que el sistema se pueda personalizar para operaciones en ambientes agresivos. El sistema es detectable por ILI y cumple con los estándares ASME PCC-2 e ISO 24817.

Mechanical Properties

Attribute–Tensile Strength 
Method– ASTM D3039
Value– 74,000 psi

Attribute– Tensile Modulus 
Method– ASTM D3039
Value– 3.1 x 106 psi

AttributePoisson's Ratio
ASTM D3039
Value– 0.37

Thermal Properties 

Attribute–Thermal Expansion 
Method– ASTM E831
Value–15.6 μm/m/C°

Attribute–Glass Transition Temp.
MethodASTM E1356
105 °C

Attribute–Max Operating Temp.
MethodASME PCC-2

Attribute–Application Temperature
Value55 °F to 120°F (13°C to 49°C)

System Properties

Attribute–Ply Thickness 
Value– 31 mils. (0.031 inches) 

Attribute–Working Time
Value40 minutes at Ambient

Attribute–Set Time
Value–2 hours

Attribute–Cure Time
Value–24 – 72 hours

Attribute–Shelf Life
Value1 year

Attribute–Available Widths
Value4, 6, and 12 inches

1.png1. Surface Preparation 

Remove all soft coatings and media blast the pipe to a 2.5 mil profile (NACE 3 minimum). Wipe the surface with a solvent such as Acetone, Toluene, or MEK.



2. Load Transfer filler 2.png

Mix the putty or paste until uniform in color and apply to any defects. Shape the filler to near net surface profile of pipe.



3.png3. Adhesive primer 
Mix equal parts of the adhesive primer until uniform. Apply the primer to the pipe surface, ensuring a minimum of 30-mil coverage. Allow the primer to sit until a “peanut butter” thickness is achieved. 



4. FormaShield Preparation 8.png
Mix epoxy parts A and B for at least 2 minutes. Apply the mixed resin onto the fabric evenly distribute on the fabric. Roll up the fabric and transfer to the prepared pipe.



5. Apply wrap to pipe 9.png

Apply cloth tightly around pipe and continue wrapping until designed layer count is achieved.



11.png6. Constrictor Wrap 
Tightly apply 4-6 layers of constrictor wrap over the repair. Then, perforate the surface of the wrap. Allow 2 hours for curing.




12.png7. Topcoat Application 
After the epoxy has cured, remove the constrictor wrap.  Apply a topcoat to the repair area, as applicable.

Click here to review the product data sheet. 

Solicitar más información sobre este producto.